Quick answer
What should a lab consider when reconstituting Selank or Semax in bacteriostatic water? Both are short synthetic heptapeptides ending in Pro-Gly-Pro, and both are handled as lyophilized powders. Their handling differs in two ways that follow from sequence. Semax (Met-Glu-His-Phe-Pro-Gly-Pro) contains a methionine, so oxidation to the sulfoxide is its main chemical risk. Selank (Thr-Lys-Pro-Arg-Pro-Gly-Pro) is rich in basic residues, so adsorption to surfaces and a slightly basic solution are the main practical issues. Bacteriostatic water, which contains 0.9% benzyl alcohol, is a workable multi-entry diluent for either. Concentration is vial mass divided by diluent volume, set out in the calculator. Product pages: Selank and Semax.
Searches that pair the two peptides usually come from labs working on neuropeptide signaling models that run both compounds side by side. They are often described by the same loose label, but chemically they are distinct, and reconstituting them as if they were interchangeable hides the sequence differences that decide their stability. This guide compares them at the bench level: what each sequence implies, how bacteriostatic water interacts with them, and how to document the stock. It does not discuss any use outside the laboratory. All materials described are for laboratory research use only; not for human consumption.
The two sequences side by side
| Property | Selank | Semax |
|---|---|---|
| Sequence | Thr-Lys-Pro-Arg-Pro-Gly-Pro | Met-Glu-His-Phe-Pro-Gly-Pro |
| Length | 7 residues | 7 residues |
| Molecular formula (V8 page) | C33H57N11O9 | C37H51N9O10S |
| V8 listed size | 10 mg | 15 mg |
| Origin | Tuftsin-derived (Thr-Lys-Pro-Arg) with a Pro-Gly-Pro tail | ACTH(4-10)-derived (Met-Glu-His-Phe-Pro-Gly-Pro) |
| Net charge character | Basic (Lys, Arg) | Mixed (Glu acidic, His weakly basic) |
| Sulfur-containing residue | None | Methionine |
| Supplied form and storage (V8 pages) | Lyophilized powder; refrigerate at 2–8 °C, −20 °C long term; protect from heat, moisture, light | Same |
Selank was developed at the Institute of Molecular Genetics of the Russian Academy of Sciences as a tuftsin analog; the Pro-Gly-Pro tail was added to resist peptidase breakdown. Semax is built on the ACTH(4-10) fragment with the same tail. Background on each is in the Selank research overview and Semax research overview, and a direct comparison is in Selank vs Semax. The research focus of both groups of studies is neuropeptide signaling in rodent and cell models; Volkova and colleagues (2016), for example, reported that Selank administration changed expression of genes involved in GABAergic neurotransmission in rats.
What the Pro-Gly-Pro tail does for stability
Peptides this short are cleared quickly by peptidases in biological fluids, and proline-containing sequences resist many of them because the pyrrolidine ring restricts the backbone and blocks cleavage at neighboring bonds. That is a biological argument about enzymes in tissue; it does not mean the peptides are immune to chemical degradation in a vial. In a reconstituted stock without enzymes, stability is controlled by chemistry: oxidation, hydrolysis, cyclization and adsorption. Proline at position 2 or 3 is relevant to one of these: diketopiperazine formation, in which the N-terminal dipeptide cyclizes and is lost, is favored by proline in the second position (Goolcharran and Borchardt, 1998). Neither compound has proline in position 2 (Selank has Lys-Pro, which places proline in position 3), so this route is less prominent than for peptides with an N-terminal X-Pro, but it remains something to look for on a chromatogram of an aged stock.
Semax: the methionine problem
Methionine is the residue most prone to oxidation in peptides. Its thioether is converted to methionine sulfoxide by dissolved oxygen, peroxide traces and light-activated processes, and further to sulfone under stronger conditions. Li, Schöneich and Borchardt (1995) reviewed these mechanisms and the factors that accelerate them. The practical steps for a Semax stock are straightforward.
- Keep the powder sealed and cold until use, and protect it from light as the product page directs.
- Use fresh diluent and avoid long exposure of the open vial to air.
- Swirl, do not vortex; shaking brings oxygen into solution.
- Avoid peroxide-containing reagents and some plastics that can leach oxidants.
- Hold the stock cold and short-lived, and inspect a chromatogram for a new, slightly earlier-eluting peak, which is the usual position of the sulfoxide in reverse-phase separations.
Benzyl alcohol does not itself oxidize methionine at meaningful rates, but old bacteriostatic water that has been repeatedly opened can accumulate oxidation products, so a fresh vial is preferable for a sensitive peptide.
Selank: basic residues and surfaces
Selank carries a lysine and an arginine on a seven-residue chain, so it is positively charged near neutral pH. Kristensen and colleagues showed that cationic peptides adsorb to glass and plastic surfaces, and Goebel-Stengel and colleagues described the effect of labware choice on recovery in peptide assays. The effect is largest at low concentrations, so a stock is often reasonably stable in its vial while a dilute working solution in an untreated tube loses material. Low-binding tubes and tips, short hold times for dilute solutions and, where the assay allows, a carrier protein, reduce the loss. The pH of an unbuffered Selank solution tends toward the mildly basic side compared with Semax, which is relevant if the stock is later combined with a pH-sensitive reagent; see bacteriostatic water explained for what the diluent contributes.
Handling comparison
| Issue | Selank | Semax |
|---|---|---|
| Main chemical risk | Hydrolysis and N-terminal cyclization over long holds | Methionine oxidation |
| Main practical risk | Adsorption of a cationic peptide to labware | Air and light exposure of the open stock |
| Diluent compatibility with 0.9% benzyl alcohol | Generally compatible; check in cell assays | Generally compatible; use fresh diluent |
| What to look for in a chromatogram | New small peaks after the main peak; loss of area | An earlier-eluting oxidized species |
| Storage after reconstitution | Cold, light-protected, short-lived, aliquoted | Cold, light-protected, short-lived, aliquoted, minimal headspace |
Reconstitution steps
- Confirm the lot number on the vial matches the certificate where one is published; see the COA page.
- Bring the vial and diluent toward a similar temperature and wipe the stopper.
- Calculate the diluent volume from the formula V = m ÷ C, using the label mass for m and the target stock concentration for C, in the reconstitution calculator. V8 publishes no fixed per-product volume table because the right stock depends on the assay.
- Add the diluent slowly down the vial wall and swirl gently until the cake dissolves.
- Inspect for clarity. Both peptides should give a clear, colorless solution; cloudiness is discussed in cloudy peptide vial after reconstitution.
- Aliquot into low-binding tubes, label with concentration, date, diluent and lot, and store cold and protected from light.
The general procedure is expanded in how to reconstitute a lyophilized peptide, and shelf-life questions in how long reconstituted peptides last.
Using both peptides in one experiment
Run-side-by-side designs invite shortcuts: one diluent bottle for both, one pipette tip, one stock vial for a mixed solution. Keep them separate. Mixed solutions confound which component carried a change in a readout and add cross-reaction questions that are avoidable. If a combined condition is the point of the experiment, prepare each stock separately and combine at the working dilution, recording the final concentration of each by the dilution relation C1 × V1 = C2 × V2. The same diluent lot should be used for both so that the benzyl alcohol level is identical across conditions. A broader view on mixed material is in peptide blends and research stacks.
Controls worth including
Because both peptides are small and chemically modest, a clean stock is easy to take for granted. Three controls cost little and protect the interpretation of an experiment. First, a diluent-only control made from the same bacteriostatic water lot, so any effect of benzyl alcohol is visible. Second, a freshly prepared stock run alongside an aged stock, so that loss of material or new species can be separated from biological variation. Third, a recorded chromatogram or at least an appearance note at the start and end of the hold. None of these require special equipment, and together they turn a claim such as "the stock was stable" into something a reviewer can check. The wider reasoning on storage evidence is in storing research peptides, and the broader catalog of related neuropeptide compounds is on the shop page.
What the vial listing can and cannot tell a lab
The V8 listings give sizes, a ≥98% purity specification by HPLC, a molecular formula, the sequence, supplied form and storage. A certificate is shown where published, and the listings for these two products currently show the certificate status as in progress, so a lab should record that fact and, if the experiment depends on it, request the document before use. The meaning of the purity figure is explained in Selank purity testing and Semax purity testing; where to look at vendor-neutral criteria is covered in how to read a COA.
References
- Volkova A, Shadrina M, Kolomin T, et al. Selank administration affects the expression of some genes involved in GABAergic neurotransmission. Front Pharmacol. 2016;7:31. doi:10.3389/fphar.2016.00031
- Li S, Schöneich C, Borchardt RT. Chemical instability of protein pharmaceuticals: mechanisms of oxidation and strategies for stabilization. Biotechnol Bioeng. 1995;48(5):490-500. doi:10.1002/bit.260480511
- Goolcharran C, Borchardt RT. Kinetics of diketopiperazine formation using model peptides. J Pharm Sci. 1998;87(3):283-288. doi:10.1021/js970325m
- Kristensen K, Henriksen JR, Andresen TL. Adsorption of cationic peptides to solid surfaces of glass and plastic. PLoS One. 2015;10(5):e0122419. doi:10.1371/journal.pone.0122419
- Goebel-Stengel M, Stengel A, Taché Y, Reeve JR Jr. The importance of using the optimal plasticware and glassware in studies involving peptides. Anal Biochem. 2011;414(1):38-46. doi:10.1016/j.ab.2011.02.009
- Meyer BK, Ni A, Hu B, Shi L. Antimicrobial preservative use in parenteral products: past and present. J Pharm Sci. 2007;96(12):3155-3167. doi:10.1002/jps.20976
- Manning MC, Chou DK, Murphy BM, Payne RW, Katayama DS. Stability of protein pharmaceuticals: an update. Pharm Res. 2010;27(4):544-575. doi:10.1007/s11095-009-0045-6
Frequently Asked Questions
Can Selank and Semax be reconstituted in the same bacteriostatic water vial?
The same bottle of diluent can be used for both if clean technique is followed, but each peptide should be reconstituted in its own vial and kept separate until the working dilution.
Why is Semax more sensitive to air than Selank?
Semax contains methionine, whose thioether oxidizes to the sulfoxide in the presence of oxygen, peroxides or light. Selank has no sulfur-containing residue.
Why does Selank stick to labware?
It carries lysine and arginine, so it is positively charged near neutral pH, and cationic peptides adsorb to glass and some plastics, especially at low concentration.
Do the V8 pages list the same storage for both peptides?
Yes. Each page states refrigeration at 2–8 °C, −20 °C for long-term storage, and protection from heat, moisture and light.
What sizes are listed for each peptide?
The Selank page lists a 10 mg vial and the Semax page lists a 15 mg vial, both as lyophilized powder with ≥98% HPLC purity.
Is there a fixed volume of diluent for each peptide?
No. The diluent volume follows from the formula V = m ÷ C for the stock concentration the assay needs; the V8 calculator performs the arithmetic.
What does the Pro-Gly-Pro tail change in a vial?
Its main documented role concerns resistance to peptidases in biological fluids. In a stock without enzymes, stability is governed by chemistry such as oxidation, hydrolysis and adsorption.
How can oxidation of Semax be detected?
Reverse-phase chromatography often shows the methionine sulfoxide as an additional peak eluting slightly earlier than the intact peptide.
Is a certificate available for both products?
A certificate is linked only where published. The listings for these two products show the status as in progress, which should be recorded in lab notes.
